Allied-telesis AT-FS909SX Manuale Utente Scaricare il pdf (Pagina 19)

AT-FS909SX Installation Guide

Installing the Switch on a Desktop

1. Locate a level, secure surface for the switch.

2. Apply the four rubber feet to the bottom of the switch.

3. Place the switch on the desktop.

Warning

The power cord is used as a disconnection device. To de-energize

equipment, disconnect the power cord.

4. Apply power to the switch by plugging the power cord into the rear of

the unit and plugging the other end into a wall outlet. Verify that the

Power LED lights green.

If the Power LED does not light green, refer to Chapter 3, for further

information.

Warning

Do not stare into the laser beam.

5. Connect the data cables and observe normal operation as indicated by

the port LEDs. Refer to Table 1 on page 3 for LED information. For

Port 1, set the MDI Button to the correct setting. Refer to Table 2 on

page 4 for the MDI setting.

6. Optional: place one of the additional serial number stickers supplied

with your switch on an accessible part of the switch for your

convenient reference.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

Nessun commento

Allied-telesis AT-FS909SX Manuale Utente Pagina 19