Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manuale Utente Scaricare il pdf (Pagina 78)

Start-up Sequence

Software Reference for x310 Series Switches

3.14 AlliedWare Plus

Operating System - Version 5.4.4C C613-50046-01 REV A

There are three possible status results displayed for each module loaded - OK, INFO,

ERROR:

■ OK means that the module has loaded correctly.

■ INFO means that an error occurred, but the device is usable.

■ ERROR means that an error occurred and device operation may be affected.

Additional specific information accompanies an INFO or ERROR status result. For example,

if a corrupt release file was set as the startup release, the following error message would

be seen:

Whether an error message results in a case of the device being unusable will depend on

the specific error and message, so will need to be dealt with on a case by case basis. If a

software release has been corrupted, as shown on start-up, a new release may need to be

loaded.

Bootloader 1.0.9 loaded

Press <Ctrl+B> for the Boot Menu

Reading filesystem...

Error: Release filename is invalid (should be x310-5.4.4C.rel)

Error: There is no backup release file set

Error: Boot failed. Please recover the system using the Boot Menu

Restarting...Bootloader 1.0.9 loaded

Press <Ctrl+B> for the Boot Menu

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 221 222

Nessun commento

Allied-telesis AlliedWare Plus Operating System Version 5.4.4C (x Manuale Utente Pagina 78